How to Fix a Hammer Head with Dents
You know tools rule when . . .
You feel the way our guest editor Helen Driggs does if her jewelry hammers are used for (gasp!) anything but jewelry. Has someone abused your tools for home repair? Listen up as our managing editor of Lapidary Journal Jewelry Artist tells you how to smooth out a damaged hammerhead and avoid divorce at the same time. –LR, Beading Daily editor
Dents can be undone
Suppose your unthinking significant other (SO) used your planishing hammer to drive a finishing nail into the trim and damaged its surface. After you come to your senses, resist the urge to commit homicide and install a lock on the studio door, you’ll find it’s possible to remove scratches, dings, and sharp edges from any hammer face by following these directions.
|1: Trace the contour of the hammerhead for reference on a piece of paper. Make a tracing of both axes of the curve. Take measurements with a caliper if you desire total control over replicating the hammer face prior to the ding.|
|2: File down to the deepest depth of the offending mark with a #3 or #2 hand file. Preserve the contour of the hammer face prior to the ding by comparing it to the tracings and measurements you made.|
|3: When the mark is filed down and the face profile of the hammer is to your liking, proceed through several grades of sandpaper from coarse to fine until the steel is absolutely smooth and scratch free.|
|4: Buff the hammerhead on a polishing arbor with Fabulustre compound until it is polished to a mirror finish. Remove excess compound with a lint-free cloth. Hide the hammer, so no one will ever use it for home repair again.|
You're only as good as your tools
How do you keep your tools in good shape and out of harm's way? How do you keep your cool if you find your jewelry pliers being used to fix the toaster? Share your tales here on Beading Daily.